Detaching the Eyeball
1. Perform procedure "Removing the Slot Covers"
(page 28).
2. Perform procedure "Removing the Camera"
(this page).
3. Detach eyeball from housing (Figure 30).
a. Turn yoke to access tabs. One tab is more
accessible than the other. Use your finger to
press this tab while, simultaneously, using a
small slotted screwdriver to press the other.
b. While pressing tabs, push up on eyeball to
detach it.
Figure 30. Loosening the eyeball
4. Detach slip ring connector (Figure 31).
Figure 31. Detaching the eyeball
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME
INSTALLATION AND SERVICE GUIDE
Removing the Camera/Lens Board
1. Perform procedure "Removing the Slot Covers"
(page 28).
2. Perform procedure "Removing the Camera"
(page 28).
3. Perform procedure "Detaching the Eyeball"
(page 29).
4. Separate yoke brackets (Figure 32).
Figure 32. Separating the yoke brackets
5. Gently pry off yoke bracket covering
camera/lens board to access bearing
assembly (Figure 33).
Figure 33. Removing the yoke brackets
29 of 37
8200-0184-14, REV. A