American Dynamics SpeedDome Ultra VII EIS Installation And Service Manual page 12

Use the following addresses for the protocols
shown:
PROTOCOL
AD Manchester,
Range: 001—064
PELCO "P," 4800 baud RS-
422, Range: 001—099
Sensormatic, 4800 baud
RS-422, Range: 001—063,
065—099
Sensormatic, RS-422
Address 64 is used for global
broadcasts
SensorNet,
Range: 001—099
VICON, 4800 baud RS-422,
Range: 001—099
SensorNet,
Range: 100—254
Address 255 is used for
global broadcasts
Dept. of Transportation
(NTCIP), 4800 baud RS-422,
Range: 301—399
Dept. of Transportation
(NTCIP), 9600 baud RS-422,
Range: 401—499
Dept. of Transportation
(NTCIP), 19.2K baud RS-422,
Range: 501—599
PELCO "P," 2400 baud RS-
422, Range: 601—699
PELCO "P," 9600 baud RS-
422, Range: 701—799
Reset HITACHI VK-xxxx(E)R
camera block from 38.4K to
4800 baud (SpeedDome Ultra
VII WITH EIS 0100+ feature
only).
PANASONIC UTC
Tyco UTC
PELCO UTC (Origins,
Standard, & Extended)
RS-422, LED diagnostic
mode for dome wiring
installations without the I/O
Board
Manufacturing Use,
Range: 901—999
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME
INSTALLATION AND SERVICE GUIDE
SW3 SW2 SW1
0 x x
0 x x
0 x x
0 6 4
0 x x
0 x x
1 x x
2 x x
2 5 5
3 x x
4 x x
5 x x
6 x x
7 x x
8 3 0
8 9 0
8 9 1
8 9 3
9 0 0
9 x x
12 of 37
2. Attach the safety lanyard to the cap on the
housing and eyeball assembly (Figure 12). Use
the M3x6 screw supplied with the lanyard.
Figure 12. Attaching safety lanyard
3. WITH POWER OFF, connect the video cable
(Figure 13).
a. Connect BNC of video micro coax cable
6003-0170-01 to BNC of video cable.
b. Feed cable through access hole in base.
c. Press the micro coax connector into the
mating receptacle in the top of the housing
and eyeball assembly. A firm snap indicates
a tight connection.
Only use this
location to secure
lanyard.
8200-0184-14, REV. A