General Settings; The General Mode Window - Cisco Fluidmesh 1200 VOLO Installation And Configuration Manual

Fluidmesh 1200 VOLO

7.4. General settings

7.4.1. The General Mode window

The General Mode window contains controls to monitor and/or change the
following settings:
• The unit's operational mode.
• The version of Prodigy currently being used by the unit.
• The unit's LAN parameters.
• If the local unit is in Bridge Mode, the Bridge ID of the remote unit to
which the local unit must be linked.
To change the General Mode settings, do the following steps:
• Click the -general mode link under GENERAL SETTINGS in the
left-hand settings menu (below).
Figure 23. Configurator GUI (General Mode)
• The GENERAL MODE dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
(page 58)).
(Figure 23
Page 58 of 169