Installing SU-I Units
Connectors and LEDs
The unit provides the following interfaces:
An Ethernet connector (marked ETH) on the rear panel for
connecting the unit to a PC.
A DC-IN 5V connector on the side panel for the power transformer.
A Monitor connector on the side panel for connecting an ASCII
terminal with terminal emulation software for configuration and
maintenance purposes.
An RF connector (marked 2) on the side panel for connecting to an
antenna.
The unit provides the following LED indicators on its front panel:
Name
Description
POWER
Power Supply
WLNK
Wireless Link
Activity
ETHERNET
Ethernet Activity
SIGNAL
Received Signal
QUALITY
Quality
Manual Revision 1.0
Table 2-4: Subscriber Unit's LEDs
Functionality
On - After successful power up
Off - Power off
Blinking - Receiving packets from the wireless link
Off - no reception of packets from the wireless link
Blinking - Reception of data from Ethernet LAN
Off - No reception of data from Ethernet LAN
Very low quality reception or not
synchronized with Access Unit
Low quality reception
(usually enabling 1Mbps traffic)
Medium quality reception
(usually enabling 2 Mbps traffic)
High quality reception
(usually enabling 3 Mbps traffic)
Installing the SU-I Subscriber Unit
2-25