Figure 2-2 illustrates the method of installing a Radio Unit on a pole,
using the brackets and open-ended bolts.
Figure 2-2: 3" Pole Installation Using Special Brackets
NOTE
Be sure to insert the open ended bolts with the grooves pointing outward, since
these grooves enable you to use a screwdriver to fasten the bolts to the unit.
Connecting the Ground and IF Cables
The Ground terminal (marked ╤) and the IF cable connector (marked IF)
are located on the bottom panel of the Radio Unit, as shown in
Figure 2-3.
To connect the ground cable:
1. Connect one end of a grounding cable to the ground terminal and
tighten the ground screw firmly.
Manual Revision 1.0
Installing the Stand-Alone AU/ Modular Base Station Equipment
2-9