Chapter 3 - Commissioning; Set-Up And Initialization - Alvarion BreezeACCESS 900 System Manual

Chapter 3 - Commissioning

Set-up and Initialization

After completing the installation process, as described in the preceding
chapter, the basic parameters must be configured to ensure that the
unit operates correctly. Once the basic parameters have been
configured, additional parameters can be remotely configured via the
Ethernet port or the wireless link using Telnet or SNMP management, or
by loading a configuration file.
NOTE
The decision on hopping frequencies to be used, based on the results of the
Spectrum Analysis survey, must be made prior to starting the process of
configuring basic parameters.
Accessing the Monitor Program
NOTE
The BS-GU does not have an external Monitor port and it should be configured via
the Ethernet port using Telnet.
To access the Monitor Program using the Monitor cable:
Use the Monitor cable to connect the Ethernet connector of the unit to
the COM port of a PC running a terminal emulation program. The COM
port connector on the Monitor cable is a 9-pin D-type plug.
1. Run a terminal emulation program, such as HyperTerminal™.
2. Set the communication parameters as shown in Table 3-1.
3. Press Enter. The Select Access Level menu is displayed.
4. Select the required access level, depending on your specific access
rights. A password entry request is displayed.
5. Enter your password and press Enter. The Main Menu is displayed.
3-2
BreezeACCESSS 900 System Manual