Alpine IDA-X001 Owner's Manual page 36

<JAPANESE CAR>
This unit
Ground Lead
3
*
• Secure the ground lead of the unit to a clean metal spot using a screw
3
(* ) already attached to the vehicle's chassis.
USB cable connection
Insert a USB cable into the unit, and fix with a lock screw.
iPod Connection (sold separately)
USB connection
Connect USB cable to an iPod with iPod Dock interface cable.
iPod Dock interface Cable
Direct connection
Connect iPod direct connector to an iPod with FULL SPEED
connection cable (KCE-422i).
FULL SPEED™
Connection Cable
(KCE-422i) (Sold separately)
34
-EN
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
USB Cable
USB cable
TM
Remove the iPod
Remove the iPod from FULL SPEED™ Connection Cable or iPod
Dock interface cable.
• If USB is connected, after the unit has been changed to a source
other than the iPod, remove the iPod. If the iPod is removed in the
iPod mode, data may cause damage.
• If sound is not output or the iPod is not recognized even when the
iPod is connected, remove the iPod once, then connect it again, or
reset the iPod.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
USB memory
Remove USB memory
Pull out USB memory squarely from the USB cable.
USB memory
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
USB cable
USB cable