Equalizer Presets; Setting The Subwoofer; Operating The External Audio Processor; Setup - Alpine IDA-X001 Owner's Manual

Equalizer Presets

9 typical equalizer settings are preset at the factory for a variety of
musical source material.
1
Press and hold AUDIO for at least 2 seconds.
The Audio Setup screen is displayed.
2
Press ENT while being selected Factory's EQ.
The Factory's EQ setting mode is activated.
3
Turn the Center Jog Dial to select the desired
equalizer characteristic, and press ENT.
4
Press BACK.
The unit returns to normal mode.
• If BACK is pressed during setting, the unit returns to the previous
item.

Setting the Subwoofer

The setting is made when an optional subwoofer is connected. If
connected, the phase of the subwoofer output can be switched. Select
the phase that your desired sound is obtained.
1
Press and hold AUDIO for at least 2 seconds.
The Audio Setup screen is displayed.
2
Turn the Center Jog Dial to select the Subwoofer,
and press ENT.
The Subwoofer On/Off setting mode is activated.
3
Turn the Center Jog Dial to select On, and press
ENT.
4
Turn the Center Jog Dial to select SUBW.Phase,
and press ENT.
The Subwoofer phase selection mode is activated.
5
Turn the Center Jog Dial to switch the phase of the
subwoofer output, and press ENT.
Select the phase to your preference.
Normal Reverse
6
Press BACK.
The unit returns to normal mode.
• If BACK is pressed during setting, the unit returns to the previous
item.
• If OFF is set in step 3, the phase cannot be switched.

Operating the External Audio Processor

You can call up the preset memory of the external audio processor from
this unit.
1
Press and hold PRESET for at least 2 seconds to
call the external audio processor mode when the
external audio processor is connected.
The AP Preset screen is displayed.
2
Turn the Center Jog Dial to select the preset
number, and press ENT.
• For the operation of external audio processor, refer to the Owner's
Manual of the external audio processor you purchased.
19
-EN