Picture Monitor Signal Level Adjustment - Sony HXCU-FB70 Service Manual

Adjustment Procedure
Adjust the VBS signal level with VBS LEVEL of M05: ANALOG VIDEO in the MAINTENANCE menu.
Equipment: SD waveform monitor
Test Point: VBS connector /rear panel
Specification:
• A = 140 ± 1 IRE (75 Ω termination)
• B = 1000 ± 7 mV p-p (75 Ω termination)
NTSC (UC, J)
A
3-4-5.

Picture Monitor Signal Level Adjustment

Adjust the PIX output signal level using the CCU color-bar signal.
Note
Set the intercom system with MAINTENANCE menu. (Refer to the Operating Instructions.)
Picture Monitor Signal Level Adjustment
Adjust the PIX output signal level with PIX LEVEL of M05: ANALOG VIDEO in the MAINTENANCE menu.
Equipment: SD waveform monitor
Test Point: PIX out connector/ rear panel
Specification:
• A = 140 ± 1 IRE (75 Ω termination)
• B = 1000 ± 7 mV p-p (75 Ω termination)
NTSC (UC, J)
HXCU-FB70
PAL (CE)
PAL (CE)
A
B
B
3-11