4. Click the [OK] button.
The CHECK screen is displayed.
5. Confirm the serial number and destination, and then click the [YES] button.
The confirmation message is displayed.
6. Confirm the above message, and then click the [YES] button.
The writing of serial number is started.
7. Check that OK is displayed in the lower right corner of the screen.
(The writing of serial number is completed.)
n
If OK is not displayed, perform the procedure from step 1 again.
End
1. Exit G6 Serial_Inputter For Service.
2. Turn off the power of this unit.
2-12 (E)
Serial number
Destination
[YES] button
Confirmation message
[YES] button
Check that OK is displayed.
SRG-300SE/301SE