1-4-3. Center Cabinet
n
The identical parts are used for the two center cabinets. Therefore, they can be attached to either the front
or rear side of the camera block.
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the CN-3766 board. (Refer to Section 1-4-1.)
3. Remove the FCB assembly. (Refer to Section 1-4-2.)
4. Rotate the FCB holder in the direction of the arrow.
5. Remove the four screws, then remove the two center cabinets.
Center cabinet
6. To install, reverse the removal procedure.
1-8 (E)
BTP
2.6
8
FCB holder
BTP
2.6
8
Center cabinet
SRG-300SE/301SE