Sony SRG-300SE Service Manual page 38

3. Type the Administrator name and Administrator password, and then click the [OK] button.
Administrator name: Administrator user name (default: admin)
Administrator password: Administrator password (default: admin)
t
If the administrator user name and administrator password are unknown, reset this unit to the
factory setting. (Refer to Section 2-1-6.)
The Network Setting screen is displayed.
4. Check the "Use the following IP address" radio button, type IP address and Subnet mask, and then
click the [OK] button.
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
When the setting is completed correctly, the Information screen is displayed.
When an error is displayed, check the LAN cable connection between this unit and PC, and then
perform the procedure from step 1 again.
5. Click the [OK] button.
2-6 (E)
Check the radio button.
"IP address" and "Subnet mask"
[OK] button
[OK] button
SRG-300SE/301SE