Sony SRG-300SE Service Manual page 26

Stepping motor assembly (PAN)
14. Remove the screw, then remove the harness guide (upper).
n
When attaching the harness guide (lower), place the tape portion of the fine-wire coaxial cable as
shown in the illustration.
15. Remove the two screws, then remove the harness guide (upper) and fine-wire coaxial cable.
16. Remove the two screws, then remove the PAN shaft subassembly and timing belt.
n
. When attaching the timing belt, loosen the two screws of the stepping motor assembly (PAN), then
fully tighten the screws while pushing them in the direction of the arrow.
. Adjust the timing belt tension so that it is the same level as the tension before being removed.
PSW
2.6
Timing belt
PAN shaft subassembly
Harness guide (lower)
PSW2.6
Fine-wire coaxial cable
1-20 (E)
Harness guide (upper)
6
6
Back side of harness guide (upper)
Tape portion
Fine-wire
coaxial cable
Hooks
Stepping motor assembly (PAN)
Screws
SRG-300SE/301SE