Stepping motor assembly (TILT)
10. Remove the two screws, then remove the TILT bearing holder (L).
11. Remove the two screws, then remove the TILT bearing holder (R).
12. Remove the timing belt from the stepping motor assembly (TILT), then remove the FCB holder.
n
. When attaching the timing belt, loosen the two screws of the stepping motor assembly (TILT), then
fully tighten the screws while pushing it in the direction of the arrow.
. Adjust the timing belt tension so that it is the same level as the tension before being removed.
. When attaching the timing belt, push it against the guide of the TILT pulley.
FCB holder sub-assembly
TILT bearing holder (L)
BTP
2.6
8
Stepping motor
assembly (TILT)
Screws
1-18 (E)
Guide
TILT pulley
TILT bearing holder (R)
Stepping motor assembly (TILT)
Timing belt
Timing belt
BTP
2.6
8
SRG-300SE/301SE