7. Disconnect the fine-wire coaxial cable from the connector (CN101) on the MD-156 board.
8. Remove the two screws, then remove the MD-156 board in the direction of the arrow.
9. Disconnect the two harnesses and the fine-wire coaxial cable from the connectors (CN102, CN401
and CN501) on the MD-156 board, then remove the MD-156 board.
Fine-wire coaxial cable
Place the cable with the
contact side facing front side.
Fine-wire coaxial cable
Harness
Black paints
CN401
BTP
2.6
8
MD-156 board
SRG-300SE/301SE
CN101
CN501
Blue paints
Harness
CN102
Fine-wire coaxial cable
Place the cable with the
contact side facing front side.
Fine-wire coaxial cable
1-17 (E)