Basic Editing; Edit Value Button; And Buttons; Entering Numeric Values - Alesis ADAT-XT20 Reference Manual

B
ASIC
EDIT V
Function Button
[LOCATE
0]–[LOCATE 9]
[TAPE OFFSET]
[TRACK DELAY]
E
NTERING
ADAT XT20 Reference Manual
E
DITING
B
ALUE UTTON
The [EDIT VALUE] button is used to turn Edit mode on and off. When
turned on, the EDIT icon will light indicating you are now in Edit mode.
At this point, you can press any one of the [LOCATE 0] - [LOCATE 9],
[TAPE OFFSET] or [TRACK DELAY] Function buttons to view and/or
edit their respective parameter settings in the display. The icons just
below the EDIT icon in the display will indicate which feature is
currently selected for editing (when in Edit mode), and which features
are on or off (when not in Edit mode). When Edit mode is selected, the
TIME counter provides a display of the selected parameter's current
setting.
The first time [EDIT VALUE] is pressed, Locate 0 will be selected.
While the EDIT icon is still on, you can press another Function button to
access its parameter(s). Press [EDIT VALUE] again to exit Edit mode;
the EDIT icon will turn off. Pressing a Function button now will toggle
that function on or off. The next time Edit mode is turned on, the display
will return to the last function you were editing before exiting Edit
mode.
When Edit Mode is on...
Edit Locate Point address
Edit Tape Offset amount
Edit Track Delay settings
B
AND UTTONS
Once a function is selected, the
decrement its setting by single values. By holding either button, the
increment or decrement value increases its speed. By simultaneously
pressing both buttons, the selected parameter is reset to 0.
N
UMERIC
If [EDIT VALUE] is held while in Edit mode, you may use the
[LOCATE 0] – [LOCATE 9] buttons as a 10-digit keypad (from 0 to 9)
to enter a specific numerical value for the currently selected parameter
in the display. Numbers are entered from left to right.
Examples: If [LOCATE 1] is pressed using this method to edit Track
Delay time (displayed as XXX.X ms), the display would show .1 ms. If
a [LOCATE 5] is now entered, the display shows 1.5 ms. If the [EDIT
VALUE] button is released at this time, the display shows 001.5 ms
and that would be the new Track Delay value. Likewise, if this
method is used to edit a Locate Point (X:XX:XX.XX) and the sequence of
numbers were entered as follows: [LOCATE 1] – [LOCATE 2] –
[LOCATE 3] , the display would successively show . 1, .12, 1.23. If
the [EDIT VALUE] button is then released, the display would show
0:00:01.23 and that would be the Locate Point's value.
Basic Operations: Chapter 4
When Edit Mode is off...
Execute a locate
Tape Offset on/off
Track Delay on/off
and buttons are used to increment or
V
ALUES
55