Alesis ADAT-XT20 Reference Manual page 73

20-bit digital audio recorder
Table of Contents

Advertisement

Chapter 4: Basic Operations
normally uses the "hours:minutes:seconds:100ths/second" format. This may
cause some confusion when locating to a specific position on the BRC, since the
XT20 will show a slightly different value when looking at the last two digits
of the TIME counter. The XT20 will locate to the same physical position that
the BRC displays, it is simply displaying 100ths/second instead of frames.
It is possible, however, to switch the XT20's TIME display so that it counts in a
30 FPS format, instead of 100ths/second. This is done by holding [SET
LOCATE] and pressing RECORD ENABLE [4]. Repeat this process to toggle
back and forth between these two modes. When set to "frames-per-second"
mode, the TIME counter will briefly read "d1SP FPS". When switched back
to "100ths-of-a-second" mode, the TIME counter will briefly read "d1SP
rE ". This feature is designed for the sole purpose of aligning the displays of
the XT20 and the BRC. The selected mode also affects how the Locate Points
are displayed and edited on the XT20.
72
ADAT XT20 Reference Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Adat xt20

Table of Contents