Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual page 52

OmniSwitch 6850-48
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to
Status and Slot Indicator LEDs
For detailed information on OS6850-48
status and slot indicator LEDs, refer to
page 2-54.
USB Port
High speed (480 Mbps) USB 2.0
port, which can be used for quick
upgrades.
OK PRI PWR BPS
OmniSwitch 6850-48 1 2 3
USB
1 2 3 4
CLASS 1 LASER PRODUCT
Console
Console Port
The OS6850-48 front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
page 2-28
10/100/1000Mbps
The OS6850-48 provides 44 fixed 10/100/1000BaseT
(5–48) and 4 fixed 10/100/1000BaseT combo (1–4).
These are auto-sensing and auto-MDIX and use RJ-45
connectors.
4 5 6 7 8 9 10 11 12 13 14 15 16 17
Combo SFP
The OS6850-48 provides four combo SFP connectors for 1000Base-X high-
speed connections.
By default, when an SFP is installed in a combo port, it takes over the port num-
ber of the corresponding RJ-45 Ethernet port. In other words, if an SFP is
installed in the slot labeled 4, Ethernet port 4 is no longer available and cannot
be used for 10/100/1000 traffic. This default setting is referred to as "preferred
fiber." Refer to "Configuring Ethernet" in the Network Configuration Guide for
detailed information, including steps for configuring combo port settings.
OmniSwitch 6850-48 Front Panel
OmniSwitch 6850 Series Hardware Users Guide
OmniSwitch 6850 Series Chassis and Hardware Components
page 2-56.
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45
September 2009
46 47 48