Status Leds - Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual

Omniswitch 6850 series
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

Status LEDs

Status LEDs
LEDs provide visual status information. These "status lights" are used to indicate conditions, such as
hardware and software status, primary role status, power supply status, primary and secondary status
(stacked configurations), fan and temperature errors, 10 Gigabit uplink status (when applicable), slot
number information, data speed, link integrity, and activity. Refer to the diagram below for detailed infor-
mation on LED states.
Slot Indicator LED
The slot indicator LED dis-
plays the switch's current slot
number. Displays 0 when the
switch is booting.
System Status LEDs
OK
PRI
PWR
BPS
OmniSwitch 6850-P48
1
2
USB
1
2
3
4
CLASS 1 LASER PRODUCT
Console
Combo Port Status LEDs
Displays solid green when an SFP is installed in the corre-
sponding port and a link state exists; blinks green when trans-
mitting or receiving traffic; off when no activity is present or
no SFP is installed.
By default, when an SFP is installed, it takes over the port
number of the corresponding RJ-45 Ethernet port. If an SFP is
installed in the slot labeled 45, Ethernet port 45 is no longer
available and cannot be used for 10/100/1000 traffic. For
detailed information on changing combo port settings, see
"Configuring Ethernet" in the Network Configuration Guide.
page 2-54
OK. Solid green when the switch has passed hard-
ware diagnostic tests and the system software is
operational. Solid amber when a hardware or sys-
tem software failure occurs. Blinks green during
normal diagnostics.
PRI. Solid green when the switch is either a
stand-alone switch or the primary switch in a
stack; solid amber if the switch status is second-
ary; off if the switch is idle (i.e., neither primary
or secondary).
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Front Panel LED Descriptions (OS6850-P48X Shown)
OmniSwitch 6850 Series Hardware Users Guide
OmniSwitch 6850 Series Chassis and Hardware Components
PWR. Solid green when the primary
(i.e., factory-installed) power supply sta-
tus is OK and the power supply is oper-
ating normally. Solid amber in the event
of a power supply failure.
BPS. Solid green when an optional
redundant power supply is installed and
operational. Solid amber if a redundant
power supply failure occurs; off when
no redundant power supply is installed.
Link/Activity LED
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Ethernet Port LEDs
10/100/1000 Ethernet port have one built-in status
LED. This LED indicate the data speed and link/
activity either PoE or non-PoE status for each corre-
sponding Ethernet port. 1000 Mbps SFP and 10000
Mbps XFP have a single LED for activity. See
2-55
for more information.
Link/Activity LED
31
32
33
34
35
36
37
38
39
40
41
42
43
44
September 2009
45
46
47
48
page

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents