Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual page 144

Roles Within the Stack
To resolve this pass-through condition, simply assign slot 1001 a new saved slot value and reboot the
module. This can be done in either of two ways:
Use the stack set slot
•
to reboot the module:
-> stack set slot 1001 saved-slot 3
-> reload pass-through 1001
Use the stack set slot command to assign the new slot value and, using the optional reload syntax in
•
the command line, reboot the module:
-> stack set slot 1001 saved-slot 3 reload
When the module comes up, it assumes the new, unique slot position—in this case, slot 3—and, because it
now has the highest slot number in the stack, it assumes an idle role (leaving the primary and secondary
roles to slots 1 and 2, respectively). There are now no duplicate numbers in the stack and all elements are
operating normally:
-> show stack topology
NI Role
----+-----------+--------+------+-------+-------+-------+-------+-------+-------
1 PRIMARY
2 SECONDARY
3 IDLE
page 4-14
command to assign the new value, then use the
State Saved Link A
Slot State
RUNNING 1 UP
RUNNING 2 UP
RUNNING 3 UP
OmniSwitch 6850 Series Hardware Users Guide
Managing OmniSwitch 6850 Series Stacks
reload pass-through
Link A Link A
Remote Remote Link B
NI Port State
3 StackA UP
1 StackB UP
1 StackA UP
command
Link B Link B
Remote Remote
NI Port
2 StackA
3 StackB
2 StackB
September 2009