Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual page 44

OmniSwitch 6850-U24X
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to
USB Port
High speed USB 2.0 port,
which can be used for quick
upgrades.
PRI PWR BPS
OK
1
OmniSwitch 6850-U24X
USB
1
25 26
25
26
2
CLASS 1 LASER PRODUCT
Console
Console Port
The OS6850-U24X front panel
provides one RJ-45 port for con-
sole connections. Console con-
nections are used by network
administrators for switch man-
agement. This female RJ-45 con-
nector provides a DTE console
connection.
Status and Slot Indicator LEDs
For information on the OS6850-U24X's
status and slot indicator LEDs, refer to
2-54.
page 2-20
1000Mbps SFP
The OS6850-U24X provides 22 non-combo SFP con-
nectors for 1000Base-X SFP connectors (1–22) and 2
combo SFP connectors for1000Base-X SFP connectors
(23–24).
2 3 4 5 6 7 8 9 10 11
3 5 7 9 11
10 12
4 6 8
XFP
The OS6850-U24X front panel
provides two for 10 Gbps Small
Form Factor Pluggable (XFP)
transceivers.
page
OmniSwitch 6850-U24X Front Panel
OmniSwitch 6850 Series Hardware Users Guide
OmniSwitch 6850 Series Chassis and Hardware Components
page 2-56.
12 13 14 15 16 17 18 19 20 21
13 15 17 19 21
14 16
18 20 22
Combo RJ-45 10/100/1000
The OS6850-U24X provides two combo
10/100/1000BaseT
By default, when an SFP is installed in a
combo port, it takes over the port number
of the corresponding RJ-45 Ethernet port.
In other words, if an SFP is installed in the
slot labeled 24, Ethernet port 24 would no
longer be available and cannot be used for
10/100/1000 traffic. This default setting is
referred to as "preferred fiber." Refer to
"Configuring Ethernet" in the Network
Configuration Guide for detailed informa-
tion, including steps for configuring
combo port settings
22 23 24
23
23 24
24
CLASS 1 LASER PRODUCT
.
.
September 2009