Canada Class A Statement - Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual

Regulatory Compliance and Safety Information
Safety and Environmental Standards
ETS 300 019 Storage Class 1.1
•
ETS 300 019 Transportation Class 2.3
•
ETS 300 019 Stationary Use Class 3.1
•
Standalone OmniSwitch 6850 Series switches comply with Class A standards for digital devices per the
FCC Part 15, ICES-003, EN 55022, CISPR 22, AS/NZS 3548, and VCCI standards. Modules with copper
connectors meet Class A requirements using unshielded (UTP) cables.
Stacks consisting of two to eight OmniSwitch 6850 Series switches comply with Class A requirements.
FCC Class A, Part 15
This equipment has been tested and found to comply with the limits for Class A digital device pursuant to
Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful inter-
ference when the equipment is operated in a commercial environment.This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions in this
guide, may cause interference to radio communications.Operation of this equipment in a residential area is
likely to cause interference, in which case the user will be required to correct the interference at his own
expense.
The user is cautioned that changes and modifications made to the equipment without approval of the
manufacturer could void the user's authority to operate this equipment.It is suggested that the user use
only shielded and grounded cables to ensure compliance with FCC Rules.
If this equipment does cause interference to radio or television reception, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient the receiving antenna.
•
Relocate the equipment with respect to the receiver.
•
Move the equipment away from the receiver.
•
Plug the equipment into a different outlet so that equipment and receiver are on different branch
•
circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional
suggestions.

Canada Class A Statement

This equipment does not exceed Class A limits per radio noise emissions for digital apparatus, set out in
the Radio Interference Regulation of the Canadian Department of Communications.
Avis de conformitè aux normes du ministère des Communications du Canada
Cet èquipement ne dèpasse pas les limites de Classe A d íèmission de bruits radioèlectriques pour les
appareils numèriques,telles que prescrites par le RÈglement sur le brouillage radioèlectrique ètabli par le
ministère des Communications du Canada.
OmniSwitch 6850 Series Hardware Users Guide September 2009
Standards Compliance
page A-5