Power Board And Cable - HP ENVY x2 12 Maintenance And Service Manual

Power board and cable

Description
Power board and cable (includes Mylar screw/POGO cover)
Before removing the power board and cable, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the Mylar shield (see
5. Remove the battery
Remove the power board and cable:
1. Disconnect the power cable (1) from the system board.
2. Lift and peel the cable off the tablet (2). (The cable is attached to the tablet with adhesive.)
3. Lift the power board and cable assembly out of the tablet (3).
Reverse this procedure to install the power board and cable.
52 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Mylar shield (WWAN models only) on page
Spare part number
L14759-001
37).