Right Usb Board - HP ENVY x2 12 Maintenance And Service Manual

Right USB board

Description
Right USB board (includes rubber, Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar,
and thermal grease)
Right USB board cable (includes Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar, and
thermal grease)
Right USB board bracket (includes Mylar screw/POGO cover)
Before removing the right USB board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
5. Remove the Mylar shield (see
6. Disconnect the battery (see
7. Remove the audio board (see
Remove the right USB board:
1. Disconnect the cable from the board (1).
2. Remove the Phillips M2.0×2.0 screw (2) that secures the board to the tablet.
58 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Display assembly on page
Mylar shield (WWAN models only) on page
Battery on page 40).
Battery on page 40).
Spare part number
L14763-001
L14765-001
L14781-001
32).
37).