Left Usb Board - HP ENVY x2 12 Maintenance And Service Manual

Left USB board

Description
Left USB board (includes rubber, Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar, and thermal
grease)
Left USB board cable (includes Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar, and thermal
grease)
Left USB board bracket (includes Mylar screw/POGO cover)
Before removing the left USB board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
5. Remove the Mylar shield (see
6. Disconnect the battery (see
Remove the left USB board:
1. Disconnect the cable from the board (1).
2. Remove the Phillips M2.0×2.0 screw (2) that secures the board to the tablet.
Display assembly on page
Mylar shield (WWAN models only) on page
Battery on page 40).
32).
37).
Component replacement procedures
Spare part
number
L14764-001
L14766-001
L14780-001
55