Front Indicator - Meyra 2.322 Maintenance And Service Manual

Front indicator

☞ Note:
If a turn-signal bulb is defective, the remaining one
blinks at double frequency.
Filament bulb:
12V/R10W BA 15s
☞ Note:
For removal or renewing the bulbs, wrap the glass body
for example in a clean, dry paper strip.
Removal
1. Lever off one of the two frontal locking springs (3) or
(4). – Therefore press a small slot screw driver into one
of the two lateral slots (5) and the wedge off the disper-
sion disc (6) carefully upward (7).
2. Press the faulty spherical bulb slightly inwards, turn and
remove from the socket.
Fitting
1. Insert a new spherical bulb. – Push the side pins (bay-
onet catch) into the recesses of the bulb holder, press
lightly against the spring and then turn the bulb until
the bayonet catch clicks into place.
2. Mount the lens. – Therefore first insert the rear spring
(4), then press down the dispersion disc (6) (2).
☞ The locking device of the front spring (3) must audibly
engage.
3
2
5
5
7
6
3
4
29