Revetment; Attaching The Insurance License Plate; Removing The Front Panel; Removing The Side Panel - Meyra Optimus 2 2.322 Service Manual

REVETMENT

ATTACHING THE INSURANCE LICENSE PLATE

– Position the insurance licence plate on the rear pan-
el and use it as a drilling tableau in order to attach
it. Then fasten the insurance license plate with suit-
able attachment material (e. g. self-tapping screws
B 4.2 x 9.5 mm or fillister head screws M 4 x 12 mm
with self securing nuts) (A).
☞
Carefully drill through the rear revetment in order
to prevent damage to cables and other parts.

REMOVING THE FRONT PANEL

– Remove the attachment screws (1) in order to re-
move the front panel.

REMOVING THE SIDE PANEL

– Model 9.928:
Unscrew the ball of the selection lever drive/push
mode resp. the drum brake lever (4).
☞
During assmebly of the selection lever drive/push
mode resp. the drum brake lever (4) remember to
insert the pressure spring.
– Model 2.322:
Pull out the drive-/push mode selection lever resp.
drum brake lever (4).
– For this remove the corresponding safety ring (6).
– Remove the corresponding rear attachment screws
(2) and (5) in order to take the side panel off.
– Loosen the plugged connection of the cables for the
front lighting on the power module. – For this push
the plug locking device then pull the plug out.

REMOVING THE REAR PANEL

– Remove the lateral attachment screws (2) and low-
er attachment screws (3) in order to take the rear
panel off.
– Loosen the plugged connection of the cables for the
rear lighting on the power module. – For this push
the plug locking device then pull the plug out.
20
1
2
3
2
3
4
A
6
5
2
2
4