Lighting; Headlamps; Front Indicator - Meyra RUNNER 1.445 Operating Manual

LIGHTING

(Option)

Headlamps

Filament bulb:
12V/3W E10
Tools:
Phillips screwdriver
Note:
Use a dry cloth to hold the glass
body of the new filament bulb.
Removal
– Switch off the control unit.
– Pull out the main fuse.
– Undo the securing screw and re-
move the lens (fig. 79).
– Pull the bulb holder (with filament
bulb) out of the lens (fig. 80).
– Screw the defective filament bulb
out of the bulb holder.
Mounting
– Screw the new filament bulb in the
socket (fig. 80). – The earth wire lies
over the thread of the bulb holder.
– Insert the filament bulb holder
(with bulb) into the lens (fig. 79).
– Mount the lens. – First insert the
top pin, then press in the lens at
the bottom and fasten it with the
securing screw.
58
79
80

Front indicator

Spherical bulb:
12V/10W BA 15s
Tools:
Phillips screwdriver
Note:
Use a dry cloth to hold the glass
body of the new filament bulb.
Removal
– Switch off the control unit.
– Pull out the main fuse.
– Undo the securing screw and re-
move the lens (fig. 81).
– Press the faulty spherical bulb
slightly inwards, turn and remove
from the socket.
Mounting
– Insert a new spherical bulb. – Push
the side pins (bayonet catch) into
the frame, exert slight pressure
against the spring and turn until
the bayonet catch clicks into place
(fig. 81).
– Mount the lens. – First insert the
side pin, then press in the lens and
fasten it with the securing screw
(fig. 82).
81
82
59