Before Use - Seiko 3B51 Instructions Manual

1
Do not use the watch in scuba diving or
saturation diving.
The various tightened inspections under simulated harsh
environment, which are usually required for watches designed
for scuba diving or saturation diving, have not been conducted
on the water-resistant watch with the BAR (barometric
pressure) display. For diving, use special watches for diving.
Do not pour running water directly from faucet.
The water pressure of tap water from a faucet is high
enough to degrade the water resistant performance of a
water resistant watch for everyday life.
78
BEFORE USE
1
■ Make sure to keep the watch suffi ciently charged
The watch operates while charging electricity by converting light
received on the dial to electrical energy. It cannot properly operate
unless the remaining energy is suffi cient. Place or store in a location
receiving light, etc., to suffi ciently charge electricity.
■ T he amount of energy stored in the watch can be checked by the
movement of the second hand.
→ C HECKING THE CHARGING STATUS page 88
■ Charging the solar battery
→ How to charge the watch page 98
→ Standard Charging Time page 99
80
WARNING
CAUTION
Do not turn or pull out the crown when the
watch is wet.
Water may get inside of the watch.
※ I f the inner surface of the glass is clouded with condensation or water droplets
appear inside of the watch for a long time, the water resistant performance of the
watch is deteriorated. Immediately consult the retailer from whom the watch was
purchased or SEIKO CUSTMER SERVICE CENTER (listed on the end of a book).
Do not leave moisture, sweat and dirt on the
watch for a long time.
Be aware of a risk that a water resistant watch may lessen its water
resistant performance because of deterioration of the adhesive on
the glass or gasket, or the development of rust on stainless steel.
Do not wear the watch while taking a bath or a sauna.
Steam, soap or some components of a hot spring may accelerate
the deterioration of water resistant performance of the watch.
■ To receive radio signals
The watch automatically receives radio signals to adjust the time
every day.
Automatic radio signal reception is carried out at two and four
o'clock during the night.
During this period of time, place the watch in a location that easily
receives radio signals without wearing it and do not move it.
→ To improve Radio Signal Reception page 93
CAUTION
1
79
1
81