Figure 3-4 Rf Video Overlay Design And Deployment Example With A +14 Dbmv - Alcatel-Lucent 7330 Product Information Manual

Consider the following limitations when planning video deployments:
•
ONTs and MDUs supporting video overlays only support specific split ratios on
the coaxial distribution, based on the ONT or MDU video receiver. For for +18
dBmV receivers, the maximum split is 1:8
•
The maximum supported length of RG-6 or RG-59 coaxial cable used for +18
dBmV units is 100 ft (30.48 m).
There are numerous criteria that effect RF video overlay. Figure
example of the factors affecting RF video overlay design and deployment.
Figure 3-4 RF video overlay design and deployment example with a +14 dBmV receiver
Conditions that need to be confirmed to ensure proper RF video overlay service, as
shown in Figure 3-4, are based on:
•
+ 18 dBmV at the ONT
•
8 dB loss at the splitter in a 1:4 split; 6.6 dB loss in a 1:3 split, and 4.6 dB loss in
a 1:2 split
•
Cable attenuation loss based on frequency and cable type:
+ 18 dBmV (at the ONT at 450 MHz) - 8 dB (splitter) - XX dBmV (RG-59
cable loss at the highest frequency based on cable type, for example
400 MHz would be -7 dB) = Final dBmV (at set-top box or TV)
For example: +18 - 8 - 7 = +3 dBmV.
+ 18 dBmV (at the ONT at 870 MHz) - 8 dB (splitter) - XX dBmV (RG-59
cable loss at the highest frequency based on cable type, for example
870 MHz would be -11 dB) = Final dBmV (at set-top box or TV)
For example: +19 - 8 - 11 = -1 dBmV.
The cable attenuation loss is based on the frequency and the type of cable used, as
listed in Table 3-7.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
3 — ONT and MDU general and interface technical specifications
Maximum 100ft (30.48m) RG-6
Maximum 100ft (30.48m) RG-59
ONT
+14 dBmV
Edition 01 ONT Product Information Guide
-xxdB
-xxdB
1:4
maximum
split
T1 to -6 dB optics input
March 2011
3-4 shows an
Set-top
box 1
Set-top
box 4
+0 dBmV minimum
19061
3-15