07/2015
Connect the lines (2-wire technique)
Minimize the length of the lines above the
lower cover to place without any problems
and do not clamp when snapping-on the
upper cover.
Connect the lines according to the labeling:
a b E P (from the button to the top), floor
push button at a – E.
Wiring example see page 9.
Snap-on the upper cover
Set on the upper cover at both adjustment
increments of the lower cover (1).
Snap-on the upper cover below with slight
pressure (2)
Open the device
There is a rectangular release opening at
the underside of the device. Insert a small
screwdriver right straight and with slight
pressure into this opening.
The upper cover can be removed at the
underside (1).
Lift the upper cover out of the two upper
adjustment increments (2).
TCS TürControlSysteme AG
E-Mail: hotline@tcsag.de • www.tcsag.de
7
floor push button
1
2
1
Subject to technical changes.
PI_ISW3130-uk
2
2 A