Cleaning - TCS ISW3130 Product Information

07/2015
1
power supply and control unit
RUN/PROG push
Button: press short
2
press until the delete-tone-melody sounds
3
or
establish voice communication
2)
to the front-station
4
power supply and control unit
RUN/PROG-push
button: shortly press
a) Not necessary, if the bell buttons have not been programmed, comp. product information of the front-door station.
1) If there sounds a Progsperr tone instead, the front-door station is equipped with a programming lock.
The programming lock can be deactivated only with the Service Device TCSK-01 or the configuration software
configo™.
2) New developed front-door stations (as of 2009) respond to that with a positive acknowledgement, if the serial number
of the indoor station was received (see product information of the front-door station).
*) for device specific indication modes of t he front-door station see product information of the front-door station
Avoid water from entering the device!
!
Do not use any abrasive detergents!
Clean the device with a dry or slightly moist cloth.
Remove stronger stains with a mild plastic cleaner.
TCS TürControlSysteme AG
E-Mail: hotline@tcsag.de • www.tcsag.de
LED blinks
1)
Programming via voice connection
shortly press
the button
LED is ON
15
Initiate
programming mode of the system is switched on
Delete a button
release
End
programming mode of the system is switched off *

Cleaning

a)
... a ring tone sounds at the front-door
1)
and indoor station
Subject to technical changes.
PI_ISW3130-uk
)
2 A