Reboot - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

5.3.5

Reboot

You can restart the HMI device manually under "Reboot". The restart can be carried out
normally or in maintenance mode.
In the following cases the HMI device is automatically restarted after confirmation:
● You have made changes to the PN-X1 interface under "Ethernet parameters Port 1" or
"Ethernet parameters Port 2", see section "PN-X1 (Page 87)".
● You have made changes under "General network settings",
see section "General (Page 91)".
● You have switched the "Enable alarm buffer" option,
see section "Alarm buffer (Page 86)".
NOTICE
Data loss
All volatile data is lost with a restart.
Make sure that no project is running on the HMI device and no data is being written to the
flash memory.
Reboot panel
"Reboot panel": Button for a simple restart of the HMI device ("soft reboot").
Reboot in mainenance mode
"Reboot in maintenance mode": Button for a restart in maintenance mode. The restart in
maintenance mode is required to reset the HMI device to factory settings.
The HMI device restarts after the "Reboot in maintenance mode" button is pressed. The
"Maintenance Mode" dialog box is displayed for a period of 10 minutes. In this period you
can connect the HMI device to a configuration PC and reset the HMI device to factory
settings with the ProSave software. Follow the description in section
"Resetting an HMI device to factory settings via ProSave (Page 133)".
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
Operating the Control Panel
5.3 System Properties
83