Fastening The Built-In Device With Mounting Clips - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

3.2.3

Fastening the built-in device with mounting clips

Requirement
● All packaging components and protective films have been removed from the device.
● The following material and tools are available:
– The mounting clips from the accessory kit
– One torque screwdriver with cross-tip insert, size 2
Procedure
Note
If the mounting seal is damaged, the degree of protection is not guaranteed.
1. Insert the device into the mounting cutout from the front.
2. Make sure that all four spring locks on the top and bottom of the device fully engage. If
necessary, gently press the device into the recess if it is not fully engaged.
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
Mounting and connecting the device
3.2 Mounting the device
37