Advertisement
Installation
Location
Select a suitable location for the PULSE FITNESS Crossclimb (Seated Independent Stepper)
before moving it. The site you choose should meet the following requirements:
A flat, level and clean surface.
Ÿ
Close to a suitable power socket.
Ÿ
Well away from sources of water (or other liquids) or away from areas that is subject to
Ÿ
condensation.
Away from direct sunlight (this can make it difficult to view the screen).
Ÿ
Note: The Seated Independent Stepper is not suitable for outdoor use.
If the chosen surface is carpet then the Seated Independent Stepper can be pushed to the
desired position on its front wheels (this is a two person procedure). However, if the surface is
more resistant, or the Seated Independent Stepper has to be lifted and lowered into place, then
four people will be required.
This equipment is heavy! We do not recommend attempting to lift it without assistance, at least
four people should lift the Seated Independent Stepper when necessary.
NEVER attempt to lift the Seated Independent Stepper by its Console or Handlebars.
Feet Adjustment
After placing the PULSE FITNESS Crossclimb (Seated Independent Stepper) in position, check
the unit's stability by attempting to rock it. Any slight rocking indicates that the unit must be
levelled. Check the front stabilising feet to determine which foot does not rest fully on the floor.
If necessary, adjust the height of the feet to compensate. Turn the feet to the left or right to
increase or decrease the height as appropriate. When satisfied, securely fasten the locknut
against the feet strut.
WARNING - When installing or adjusting any piece of Pulse Fitness equipment, DO NOT leave
any adjustment devices projecting which could cause injury to any third party.
CAUTION
Locknut
6
Advertisement
