Advertisement
Where to place the PULSE FITNESS Crossclimb (Seated Independent Stepper)
Following all safety instructions move the PULSE FITNESS Crossclimb (Seated Independent
Stepper) to the location in which it will be used. Allow a clearance of 1.0m (3.28ft.) in the
direction the Seated Independent Stepper is accessed from. Allow at least 0.6m (2ft.) on the
side of the Seated Independent Stepper. Mount the PULSE FITNESS Seated Independent
Stepper by grasping the Handles and carefully stepping on the Pedals. To dismount the
Seated Independent Stepper, step off the Pedals while still holding handlebars.
How to Stabilise the PULSE FITNESS Crossclimb (Seated Independent Stepper)
Follow all safety instructions. Move the Seated Independent Stepper to the location in which it
will be used.
Install External Power Supply
The Consoles are powered by an external AC 12-Volt power supply. Plug in the power to the
external power connector on the side of the Seated Independent Stepper and then plug the
cord into an AC outlet. The Console should begin its boot-up cycle. The Consoles can show a
message indicating they are initialising (which may take upto approximately 2 minutes).
Note: If any of the Consoles do not light up, contact PULSE FITNESS' Global Service Team.
Use only the power supply provided by PULSE FITNESS in order to ensure against unsafe
operation.
0.6m /
2.0ft
1.0m /
3.28ft
4
0.6m /
2.0ft
Advertisement
