Restoring The Factory Settings - Korg NAUTILUS Series Operation Manual

Restoring the factory settings

Restoring the original sounds
You can easily restore the Programs, Combinations, Drum
Kits, Wave Sequences, Arpeggio Pattern, Set Lists, and EXs
samples to their original state as shipped from the factory.
This is done by loading the PRELOAD.PCG file, which is
included on the internal drive.
This operation will erase all of the internal NAUTILUS
sounds. If there are any non-factory sounds that you want
to keep, save them to disk now! For more information,
see "Saving data" on page 203.
Make sure that Memory Protect is off
Before loading, make sure that Memory Protect is turned
off:
1. Press the MODE button to select GLOBAL mode.
2. Go to the Basic tab of the Basic Setup page.
3. Make sure that all of the Memory Protect check-boxes
are not checked.
Loading from the internal drive
Generally, it will be more convenient to load sounds from
the internal drive:
1. Press the MODE button to select MEDIA mode.
2. Go to the Load tab of the File page.
3. Use Drive Select to select HDD.
The LCD screen will show the files and folders on the
internal drive.
4. Touch the FACTORY folder to select it.
5. Press the on-screen Open button.
The LCD will now show the contents of the FACTORY
folder.
6. Select the PRELOAD.PCG file.
7. Press the Load button.
The Load PCG dialog box will appear.
Internal drive and Media information Restoring the factory settings
8. Use ".PCG Contents" to select the data you want to
load. To completely restore the factory sounds, select
All.
"All" will load all of the factory sounds, including
Programs, Combinations, Set Lists, Drum Kits, Wave
Sequences, Drum Track patterns, and Arpeggio Patterns.
For more information on the factory sounds, see
"Program bank contents" on page 26, "Combination bank
contents" on page 55, "Drum Kit memory structure" on
page 193, "Wave Sequence banks" on page 183, and
"Arpeggio Patterns" on page 157.
9. Select the PRELOAD.KSC checkbox.
10.Set ".KSC Allocation" to Clear All.
11.Set the Load Method for EXs and User Sample Banks
to KSC Settings.
12.Press the OK button to load the data.
Next, to make sure that the KSC loads automatically at
startup:
13.Go to the GLOBAL > Basic– KSC Auto-Load page.
14.In the list of KSCs, check the Auto-load box next to
PRELOAD.KSC.
15.Un-check all of the other KSCs.
255