Dremel 3D40 FLEX Original Instructions Manual page 543

4. The flexible build plate can be installed on top of
the build plate holder by sliding it backwards at an
angle so that the corners of the flexible build plate
slide under the notches at the back of the build
plate holder. Release the flexible build plate so it
sticks on top of the magnet, and close the latches
at the front to hold it in place.
TIP: It is much easier to remove and install the
flexible build plate if the build plate holder is
already installed in the printer. In general, once the
build plate holder is installed in the printer you do
not need to remove it, you only need to remove the
flexible build plate.
dle
FIG. 5
LIFT
5. The build plate holder can be removed by pinching
the clip located at the front of the build platform
and lifting the build plate holder off the base,
figure 7.
6. Install the build plate holder using the build platform
clips.
Clip Clip
PRESS
Clip
543