Initial Setup - Dremel 3D40 FLEX Original Instructions Manual

INITIAL SETUP

PREPARING BUILD PLATFORM
DO NOT DROP THE BUILD
WARNING
!
PLATFORM. TEMPERED GLASS
PLATE MAY BREAK AND RESULT IN PERSONAL
INJURY.
DO NOT REMOVE TEMPERED
WARNING
!
GLASS PLATE FROM PLASTIC
HOLDER. CONTACT WITH TEMPERED GLASS PLATE
EDGE MAY RESULT IN PERSONAL INJURY.
BEFORE EVERY BUILD MAKE
CAUTION
!
SURE THAT THE FLEXIBLE
BUILD PLATE IS COVERED WITH DREMEL
SPECIFIED BUILD TAPE. USE OF IMPROPER BUILD
TAPE MAY RESULT IN EQUIPMENT DAMAGE AND
POOR OBJECT BUILD QUALITY.
1. Your build plate consists of two parts: the flexible
build plate, and the build plate holder. The build
plate holder has a magnetic surface to attach the
flexible build plate to, and it has two notches in the
back and movable latches in the front to hold down
the corners of the flexible build plate.
2. The flexible build plate can be removed from the
build plate holder by rotating the movable latches
towards you (A), lifting the flexible build plate up by
the blue handles (B), and pulling it out towards you
(C), figure 3.
Notch
FIG. 4
Handle
B
A
3. The flexible build plate comes with build tape
installed. To remove it, lift it up from the tab at the
front corner and slowly peel off. To install a new
build tape, remove adhesive liner from build tape
and place build tape over flexible build plate. For
best results, apply build tape at center of flexible
build plate and smooth outward to remove any air
bubbles, figure 4.
Flexible Build
Flexible Build
Plate
Build Plate
Holder
Latches
20
FIG. 3
Build Tape
Notch
B
A
Handle