Heat Sink Torx T30 Nut Replacement - Lenovo ThinkSystem SR850 V2 Maintenance Manual

Figure 56. Installing the flash power module into a horizontal holder
Figure 57. Installing the flash power module into the vertical holder
Press and release the retaining latch.
Align the flash power module with the holder hinge.
Rotate the other end of the module inward until it is secured in the holder.
Close the retaining latch.
After this task is completed
1. Install the PCIe riser assembly (see "Install the PCIe riser assembly" on page 165).
2. Connect the cable to the corresponding RAID adapters.
3. Proceed to complete the parts replacement (see "Complete the parts replacement" on page 218).

Heat sink Torx T30 nut replacement

Follow the instructions in this section to remove and install a heat sink Torx T30 nut.
Remove a heat sink Torx T30 nut
Follow the instructions in this section to remove a PEEK (Polyether ether ketone) Torx T30 nut on the heat
sink.
About this task
ThinkSystem SR850 V2 Maintenance Manual
140