Lenovo ThinkSystem SR850 V2 Maintenance Manual page 178

2. Recycle the component in compliance with local regulations.
Install the power backplane
Follow instructions in this section to install the power backplane.
About this task
Attention:
• Go over "Installation Guidelines" on page 107 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
•
https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Align the bottom connector on the backplane to the corresponding connector on the system board,
and push the backplane in.
Figure 85. Installing the power backplane
Step 2. Route the power backplane cable through the cable clip, and connect it to the power backplane.
ThinkSystem SR850 V2 Maintenance Manual
170