Lenovo ThinkSystem SR850 V2 Maintenance Manual page 207

Figure 115. Removing the security bezel
Install the security bezel
Follow the instructions in this section to install the security bezel.
About this task
Attention:
• Go over "Installation Guidelines" on page 107 to ensure that you work safely.
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Insert the tabs on the security bezel into the slots on the right rack handle; then, press and hold the
release latch, and rotate the security bezel towards the chassis until the other side clicks into place.
Figure 116. Installing the security bezel
Step 2. Insert and rotate the key counterclockwise to lock the security bezel.
.
Chapter 4 Hardware replacement procedures
199