Lenovo ThinkSystem SR850 V2 Maintenance Manual page 219

b. If you do not specify any of these parameters, OneCLI will use the default values. When the
default values are used and OneCLI is unable to access the Lenovo XClarity Controller
using the online authenticated LAN access method, OneCLI will automatically use the
unauthenticated KCS access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
– Online KCS access (unauthenticated and user restricted): You do not need to specify a value
for access_method when you use this access method.
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
Examples that do not use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
– Remote LAN access, type the command:
Note: When using the remote LAN/WAN access method to access Lenovo XClarity Controller
from a client, the host and the xcc_external_ip address are required parameters.
[−−imm xcc_user_id:xcc_password@xcc_external_ip]
or
[−−bmc xcc_user_id:xcc_password@xcc_external_ip]
Where:
xcc_external_ip
The BMC/IMM/XCC IP address. There is no default value. This parameter is required.
xcc_user_id
The BMC/IMM/XCC account (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Note: BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are all
valid for this command.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> --host <xcc_ip>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> --host <xcc_ip>
4. Reset the Lenovo XClarity Controller to the factory defaults. Go to
topic/com.lenovo.systems.management.xcc.doc/NN1ia_c_resettingthexcc.html
Enable TPM
The server supports Trusted Platform Module (TPM).
Note: For customers in Chinese Mainland, integrated TPM is not supported. However, customers in Chinese
Mainland can install a TPM adapter (sometimes called a daughter card).
When a system board is replaced, you must make sure that the TPM 2.0 firmware is updated to the latest
version and the TPM policy is set correctly.
CAUTION:
https://sysmgt.lenovofiles.com/help/
for more information.
.
Chapter 4 Hardware replacement procedures
211