Figure 30 Device Access Fqdn - Yealink SIP-T4 Series Configuration Manual

Figure 30 Device Access FQDN

Click the Files and Authentication link and then select the option to rebuild all the
7)
system files.
Firmware files must be obtained from Yealink. These files are not included in the
import. Complete the steps in section
define the static firmware files and to upload the firmware.
NOTE: The non-firmware static files in section
normally included in the import.
After importing the DTAFs, restart the Application Server to load the TimeZoneAlias
8)
files.
Update the device profile type language setting according to instructions provided in
9)
section
5.2.2.2 Configuration Method 2: Manual
This section identifies the basic steps necessary for an administrator to manually configure
BroadWorks to add the Yealink T4x IP Phone as a Device Management-enabled device
type. This method should not be used except in special cases as described in the opening
to section 5.2.2 Configure BroadWorks Device Profile
For more detailed instructions on the manual configuration, see the BroadWorks CPE Kit
Usage Guide
The steps in this section can also be followed to update previously imported or configured
device profile type(s) with new configuration files and firmware.
If there are DTAFs for more than one device model, these steps must be completed for
each model.
BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE
2017 BROADSOFT INC.
©
5.2.2.2.4 Language Mapping.
[8] and the BroadWorks Device Management Configuration Guide [2].
5.2.2.2.2 Define Device Profile Type Files
5.2.2.2.2 Define Device Profile Type Files
Type.
to
are
20-BD5476-00
PAGE 54 OF 150