Yealink SIP-T4 Series Configuration Manual page 53

The import method should be used if all of the following prerequisites are met:
The BroadWorks Release is 17.0 or later.

The device profile type(s) being imported do not already exist on the system. (If either

a previous import or manual configuration was done, then the import fails.)
There is a DTAF file available for import with a BroadWorks release level that is the

same as or prior to the release to which it is being imported. If the DTAF file is at a
release level later than the release being imported to, then the import can fail.
Otherwise, use the manual method.
For more detailed instructions, see the BroadWorks CPE Kit Usage Guide
BroadWorks Device Management Configuration Guide [2].
5.2.2.1 Configuration Method 1: Import
This section identifies the steps necessary to make use of the Device Management import
feature to configure BroadWorks to add the Yealink T4x IP Phone as a Device
Management-enabled device type. Also, see the BroadWorks CPE Kit Usage Guide
Download the Yealink T4x IP Phone CPE kit from BroadSoft Xchange at
xchange.broadsoft.com. Extract the DTAF file(s) from the CPE kit. These are the import
files. Repeat the following steps for each model you wish to import.
Log in to BroadWorks as an administrator.
1)
Browse to System → Resources → Identity/Device Profile Types and then click
2)
Import.
Select Browse to find the extracted DTAF file for the model and then click OK to start
3)
the import.
After the import finishes, complete the following post-import configuration steps:
Browse to System → Resources → Identity/Device Profile Types.
4)
Perform a search to find the imported Yealink device profile type, Yealink T46G.
5)
Browse to the Profile page and change the Device Management Device Access
6)
FQDN to your Xtended Services Platform (Xsp) or Xtended Services Platform cluster
address.
BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE
2017 BROADSOFT INC.
©
[8] and the
[8].
20-BD5476-00
PAGE 53 OF 150