Yealink SIP-T4 Series Configuration Manual page 25

4.3.1.2 Joe's Phone Configuration – MAC.cfg
The following steps are used to configure line 1 for Joe's phone. This line rings when Joe
is called, so it has Joe's authentication information.
Step
Step 1
Step 2
Step 3
Step 4
The following steps are used to configure line 2 for Joe's phone. This line rings when Bob
is called, so it has Bob's authentication information.
Step
Step 1
Step 2
Step 3
Step 4
BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE
2017 BROADSOFT INC.
©
Command
Configure line as shared.
account.1.shared_line = 1;
Set Register User ID.
Example:
account.1.user_name = 2405552222_1;
Enable SIP Authentication.
Example:
account.1.Auth_Name = joebrown;
account.1.password = joeb;
Configure display name.
Example:
account.1.Display_Name = Joe Brown;
Command
Configure line as shared.
account.2.shared_line = 1;
Set Register User ID.
Example:
account.2.user_name = 2405552222_2;
Enable SIP Authentication.
Example:
account.2.Auth_Name = bobsmith;
account.2.password password = bobs;
Configure display name.
Example:
account.2.Display_Name = Bob Smith;
Purpose
Configure the line as "shared"
(as opposed to "private").
The register user ID must
correspond with the line/port
setting on BroadWorks.
If the Authentication service is
configured on BroadWorks, these
parameters must be configured
to match the BroadWorks
settings.
This line rings when Joe is
called, so it has Joe's
authentication information.
Configure the name to be
displayed on the device for this
line.
Purpose
Configure the line as "shared"
(as opposed to "private").
The register user ID must
correspond with the line/port
setting on BroadWorks.
If the Authentication service is
configured on BroadWorks, these
parameters must be configured
to match the BroadWorks
settings.
This line rings when Bob is
called, so it has Bob's
authentication information.
Configure the name to be
displayed on the device for this
line.
20-BD5476-00
PAGE 25 OF 150