Table of Contents
Advertisement
3. Remove the top cover in the arrow direction.
Top cover
4. Reattach the top cover in the reverse order of removal.
n
When reattaching the top cover, tighten the eight
screws with the following procedure.
(1) Temporarily tighten the two screws 1.
(2) Adjust the position of the top cover in the arrow
dirention.
(3) Tighten the four screws 2.
(4) Fully tighten the two screws 1 temporarily
tightened in step (1).
(5) Tighten the screws 3 and 4 sequentially.
2 B3 x 6
4 B3 x 6
3 B3 x 6
1 B3 x 6
1-6 (E)
Top cover
2 B3 x 6
1 B3 x 6
1-4-2. Removing/Reattaching the Rear
Assembly
1. Remove the top cover. (Refer to Section 1-4-1.)
2. Remove the five screws, and disconnect the connectors
from the connectors CN4, CN6 on the MB-1003
board.
B3 x 6
B3 x 6
MB-1003 board
CN6
CN4
Rear assembly
WLL-RX55
Advertisement
Table of Contents
