Using The Freeze Feature; Adjusting The Picture; Selecting The Picture Mode; Adjusting The Picture Quality - Toshiba Regza 42XV545U Owner's Manual

52XV545U_EN.book Page 49 Monday, August 4, 2008 10:54 AM

Using the FREEZE feature

To use the FREEZE feature:
When viewing the TV, press B to make the picture
1
a still picture.
To return to the moving picture, press B again (or
2
any other button).
Note: If the TV is left in FREEZE mode for more than 15
minutes, the FREEZE mode will automatically be released
and the TV will return to moving picture.
Using the FREEZE function for any purpose other than your
private viewing may be prohibited under the Copyright Laws
of the United States and other countries, and may subject
you to civil and criminal liability.

Adjusting the picture

Selecting the picture mode

You can select your desired picture settings from the
following modes, as described below.
Mode Picture Quality
Automatically adjusts picture settings
AutoView based on ambient light conditions and
input signal content
Sports Bright and dynamic picture
Standard Standard picture settings
Movie Lower contrast for darkened room
Designed for viewing of PC tables and
PC
documents
Designed for viewing of media from a
PC Fine
Toshiba REGZA LINK PC.
Preference Your personal preferences
Note:
• PC mode is available for HDMI and PC inputs only (grayed
out for other input sources).
• PC Fine mode is only available when on an HDMI input with
Enable REGZA LINK set to On and a Toshiba REGZA LINK
PC connected (- page 61).
• Because the AutoView mode automatically adjusts picture
settings based on ambient light conditions and input signal
content, most items in the Picture Settings and Advanced
Picture Settings menus are grayed out when it is selected.
Chapter 6: Using the TV's features
From the Video menu, highlight Mode and press T.
1
2
Press B or b to select the picture mode you prefer
and press T.
Note: The picture mode you select affects the current
input only. You can select a different picture mode for
each input.

Adjusting the picture quality

You can adjust the picture quality (Contrast, Backlight,
DynaLight™, Brightness, Color, Tint, and Sharpness) to
your personal preferences.
Selection
Contrast
Backlight*
DynaLight**
Brightness
Color
Tint
Sharpness
* Backlight
This feature adjusts the brightness of the entire screen. When in
video mode and no signal is input, this will automatically be set to 0.
(Settings are stored in memory.)
** DynaLight
This function automatically strengthens the black coloring of dark
areas in the video according to the level of darkness.
To adjust the picture quality:
1
From the Video menu, highlight Picture Settings
and press T.
2
Press B or b to select the picture quality you want to
adjust (Contrast, Backlight, DynaLight,
Brightness, Color, Tint, or Sharpness), and then
press C or c to adjust the setting, as described in the
table above.
3
To save the new settings, highlight Done and press
T.
You can use any of the picture modes (- "Selecting
the picture mode," above left) as a starting point for
adjusting the picture settings.
To revert back to the base mode that you began
adjusting the picture settings from, highlight Reset
and press T.
The picture qualities you adjusted are automatically
saved in the Preference mode (- "Selecting the picture
mode," above left) until Reset is selected.
Pressing C Pressing c
lower higher
darker lighter
On/Off On/Off
darker lighter
paler deeper
reddish greenish
softer sharper
XV545U (E/F) Web 177.8:228.6
49