Roller Removal and Installation
1. Remove the fasteners securing the guard and roller
adjustment housing to the side plate (Fig. 24) or un
screw the upper cone nut and drop the threaded rod out
of the adjustment housing (Fig. 25).
2. The threaded rod and collar assembly can be re
moved from the roller by sliding it off the shaft at both
ends (Fig. 25).
IMPORTANT: When assembling a new roller to the
cutting unit mount the roller so that the roller shaft
"locknut" is on the right side of the cutting unit
(Fig. 25). (As viewed by the operator sitting on seat
of machine). This prevents the lock nut from loos
ening during operation.
Repairs
Page 7 - 16
Figure 24
1. Guard
2. Roller adjustment housing
3. Side plate
4. Mounting fasteners
Figure 25
1. Cone nut
2. Rod and collar assembly
3. Flex locknut
Reelmaster
®
335-D