Toro Reelmaster 335-D Service Manual page 235

Installing Axle on Machine
1. Support axle under machine with a jack.
2. Install axle pivot pin to secure axle to frame. Make
sure to install thrust washers between axle pivot and
frame.
3. Install hydraulic motor to adaptor housing.
4. Install wheels to axle. Tighten lug nuts to a torque of
45 - 55 ft-lb.
5. Fill axle with SAE 80-90W EP gear lube. Lubricant
capacity is approximately 80 oz. (2.5 U.S. qt.).
6. Check rear wheel toe-in and adjust if necessary.
Rear wheel toe-in 0.25 in.
®
Reelmaster 335-D Page 6 - 21 Repairs